GF-RP48 OBS setting

JettDriver

Hi, I have set up the GF-RP48 module with the rotary knobs to control the OBS on the C172. They work fine for rotating the OBS card in fine increments of one degree. But when I need to rotate the card 30 or more degrees it goes much too slow and it takes too many rotations of the knob. How can I adjust the settings to get both, fine control and larger control. I think a setting of one and ten degrees should work.

Thank you,

Ed

TonyGFT

Hi Ed,

I have contacted our Tech Support and they will be notifying you with answers to your questions above.  Thank you! And Happy Flying!

Tony

Ohsirus

Did you set both the fast and slow rotates?

Ohsirus

I should have asked if you were using FSUIPC registered.

Ohsirus

FSUIPC is a very powerful tool and suggest you read a few tutorials or FAQs on its uses. There should be some manuals under your FSX or 9 /modules/fsuipc/manual folder.

Ohsirus

Here's some Offsets once you get started

1026 Vor1 Obi Dec Fast (–10)
1027 Vor1 Obi Inc Fast (+10)
1028 Vor2 Obi Dec Fast (–10)
1029 Vor2 Obi Inc Fast (+10)

JettDriver

Hi Ohsirus,

Can you please direct me to were that setting is or how I set that?  I did not see that capability when I set the rotary knobs.

Thanks, Ed

JettDriver

No I am not.  I have heard of it and actually downloaded it but I'm not that familiar with using it.

JettDriver

I understand it is very usefull so I will get the registered version.

Is this were I make those setting for fast and slow?  Will this cause the rotary know to have both settings and due either depending on how fast the knob is rotated?

JettDriver

I meant "knob "instead of "know" and "do" instead of "due"

JettDriver

I am purchasing FSUIPC right now and will give it a try.

Thanks for you help Ohsirus,

Ed

JettDriver

Excellent. Thanks!

JettDriver

I guess these are settings I put in under FSUIPC?